Kestokol D 4700 UV
EN 204/D4 adhesive

Kestokol D 4700 UV is EN 204 D4 classified PVAC-adhesive for face- and finger jointing of non-structural window and external door production wood blanks.

Special features

  • Suitable for outdoor use when covered with a surface covering
  • One-component
  • Excellent strength




Kestokol D 4700 UV is a reactive PVAc-dispersion adhesive, which is well suited for finger jointing of high flexural strength. Due to its D4 water resistance durability class, Kestokol D 4700 UV can be used for exterior applications exposed to weather when covered with an adequate surface covering, or indoors for applications with frequent long-term exposure to running or condensation water. Contains a tracer that is visible under UV-light to assist checking the adhesive spread.

Package Size Product Code
Kestokol D 4700 UV IBC cont T3800.994
Kestokol D 4700 UV kontti T3800.992





White, after drying transparent Glows under UV-light (100-390 nm).


2500 mPas (Brookfield, RVT +20 °C)

Open time

6 min (150 g/m²)

Pressing time

15 min. (Pine, 12 % wood moisture, temperature 20 °C, 50 % RH)

Compression pressure

0.5 N/mm²

Minimum film forming temperature

+7 °C

Wood moisture content

7–15 %


In unopened containers, above +1 °C, for 4 months. After long storing, stir before use.

Instructions for use

Check that the joints fit well. Apply adhesive one sided evenly. Assemble and press the parts together aiming at an even squeeze out for the whole length of the joint. Joints can be pressed in a cold, hot or high frequency press. The final strength and water resistance of the bond is reached within 7 days.

With some wood types the adhesive’s acidity may cause discolouration in the adhesive bond. If in contact with iron, some discolouration in the adhesive bond may occur.

Additional information

The information given in this product data sheet is based on our tests and our practical knowledge. The technical data is defined in standard conditions. Variations in local working conditions and methods will affect the product performance and result. The result is also strongly affected by working methods. We guarantee the high quality of our products according to our Quality Management System. No liability can be accepted from incorrect use of the product or prevailing conditions, over which we have no control. Thus, we cannot be held responsible for the final result. The user of the product must test the product’s suitability for the intended application.

Environment and safety

Avoid unnecessary skin contact and exposure with the fresh product, use safety gloves. Refer to material safety data sheet. For information on product and package disposal, go to