Kiilto Pro Solid
Parquet adhesive
PVAc-based adhesive with a high solid content for permanent installations. Compatible for impact sound insulation cork, mosaic and block parquet.
Special features
- High solid content
- Easy-spread adhesive
Links
Materials
For absorbent and non-absorbent surfaces indoors, suitable in dry areas.
Compatibility for gluing coverings:
- Engineered floor
- Mosaic parquet
- Base parquet
- Block parquet on plywood is also used, but only in combination with mechanical fixing
Suitable with underfloor heating and wheels traffic.
| Package Size | Product Code | EAN Code |
|---|---|---|
| 15 l / 19 kg | T1375.015 | 6411511375152 |
+18–25 °C
1.7 m²/l
approx. 1.3 kg/l
Freezing (adhesive joint is cold-resistant)
approx. 20 min (+20 °C, 50 % RH)
15 l
18 months from production date in unopened packaging. Must not be exposed to temperatures below +5° C or above +30° C. After long storing, stir before use.
Concrete: max 80%
PVAc
RH in the air must be kept between 30-60%
The substrate must be dry, firm, even and free from dust and adhesion-impairing substances. In general, levelling of concrete substrates with a suitable low-alkaline levelling compound from Kiilto is recommended. If the substrate is plywood, it should be approved by the board manufacturer.
Acclimatization of the wooden floor must take place for at least 48 hours before installation.
Note! When gluing wooden floor the substrate should have a surface tensile strength > 1.5 MPa.
Distance to wall or solid objects must be at least 5 mm depending on the type of wooden floor. Always follow the wooden flooring manufacturer’s recommended installation instructions.
Working method:
• Apply enough adhesive with a suitable notched trowel.
• Install the wooden floor in the working time for wet bonding within 20 minutes.
• Press the wood floor firmly to make full contact with the adhesive.
• Check to ensure full wetting of the wooden floor back is achieved
Installation of wooden floors must always be installed in wet adhesive.
Note! Recommend sanding and treatment with lacquer or oil no earlier than 3–6 days after installation, depending on the prevailing working conditions.
CLEANING
Fresh stains can be removed with water. Hardened glue can only be removed mechanically. Always follow the floor manufacturer's care instructions.
The working times specified in this product sheet are based on laboratory tests at a temperature of +18-20°C and humidity of 50% RH. Note that drying times are affected by temperature and humidity. Variations in local working conditions and practices affect the product’s performance and results. We guarantee the high quality of our products according to our Quality Management System. We take no responsibility for incorrect use of the product or prevailing working conditions that we have no control over. We cannot be held responsible for the final result. Correct use of the product assumes that the user has read and is aware of the contents of the work instructions, if any.
We recommend using suitable protective gloves and goggles. In case of eye contact, rinse immediately with water. Avoid unnecessary skin contact with the fresh product, in case of skin contact wash with soap and water. See more information in the safety data sheet. More information on the disposal of the product and packaging can be found at www.kiilto.com.