Kiilto Pro Lino
Floor adhesive
Floor adhesive for permanent installations. Compatible for bonding most floor coverings of Linoleum, textile and needle felt.
Special features
- Good tack
- Strong adhesion
- High solids content
- Easy to apply
- Free from 2-Ethylhexanol
Links
Materials
For both absorbent and non-absorbent substrates indoors, suitable for dry areas. Compatibility for bonding most coverings:
- Linoleum with structured or integrated backing
- Corkment, Elafono
- Bulletin board
- Textile coverings with structured or integrated backing
Suitable with underfloor heating and castor wheels traffic
| Package Size | EAN Code |
|---|---|
| 10 l | 6411511016109 |
+18-20 °C
Linoleum 3 m²/l
Textile backed floorings 3 m²/l
1.2 kg/l
freezing
10 l plastic package
In unopened packaging for 18 months. Must not be exposed to temperatures below +5° C or above +30° C. After long storing, stir before use
-concrete: max. 85 % RH
- wood 8...12 %
Acrylate copolymer
wet bonding 0-20 min.
The substrate must be dry, firm, even and free from dust and adhesion-impairing substances. Generally, levelling of concrete substrates with a suitable low-alkaline levelling compound from Kiilto is recommended.
Note! For areas with castor wheel traffic, the substrate should have a surface tensile strength > 1.0 MPa. Always follow the flooring manufacturer’s recommended installation instructions.
Working method:
- Apply enough adhesive with a suitable notched trowel.
- Install the covering after a short airing time and within half the working time for wet bonding.
- Check to ensure good wetting of the covering back is achieved
- Roll/press the material firmly.
Note! Floor coverings linoleum and textile with structured backing should always be installed in working time wet bonding.
Kiilto Pro Lino is approved for Forbo Marmoleum, Netfit installations.
CLEANING
Fresh stains can be removed with water. Dried stains should be removed mechanically. Wet the stain with a strong alkaline cleaner or xylene, wait 5-10 minutes and gently rub the surface with a red pad, repeat treatment if necessary. Finish by rinsing the surface with clean water. Always follow the floor manufacturer’s care instructions.
The working times specified in this product sheet are based on laboratory tests at a temperature of +18-20°C and humidity of 50% RH. Note that drying times are affected by temperature and humidity. Variations in local working conditions and practices affect the product’s performance and results. We guarantee the high quality of our products according to our Quality Management System. We take no responsibility for incorrect use of the product or prevailing working conditions that we have no control over. We cannot be held responsible for the final result. Correct use of the product assumes that the user has read and is aware of the contents of the work instructions, if any.
We recommend using suitable protective gloves and goggles. In case of eye contact, rinse immediately with water. Avoid unnecessary skin contact with the fresh product, in case of skin contact wash with soap and water. See more information in the safety data sheet. More information on the disposal of the product and packaging can be found at www.kiilto.com.