Kiilto Pro Flexsilan
Parquet adhesive
SMP-based semi-elastic floor adhesive for permanent installations. Compatible for most types of parquet. Specially for solid wood floors.
Special features
- Specially for solid wood floors
- Easy-spread adhesive
- Contains no water
- Does not contain plasticizers
Links
Materials
For absorbent and non-absorbent surfaces indoors, suitable in dry areas.
Compatibility for gluing coverings:
- Engineered floor
- Mosaic parquet
- Base parquet
- Solid wood
- End grain floor
Suitable with underfloor heating and wheels traffic.
| Package Size | Product Code | EAN Code |
|---|---|---|
| 10 l / 16,5 kg | T3425.010 | 6411513425107 |
+18–25 °C
paste spreads easily
approx. 1.7 m²/l, approx. 1.0 kg/m2
approx. 1.65 kg/l
freezing
approx. 30 min (+20 °C, 50 % RH)
10 l
9 months from production date in unopened packaging. Must not be exposed to temperatures below +5° C or above +30° C. An opened package must be used within 2-3 days.
concrete: max. 3,0 p-% or 80 % RH
wood: 8–12 %
Silyl-modified polymer (SMP)
RH in the air must be kept between 30-60%
The substrate must be dry, firm, even and free from dust and adhesion-impairing substances. In general, levelling of concrete substrates with a suitable low-alkaline levelling compound from Kiilto is recommended. If the substrate is boards, it should be approved by the board manufacturer.
Acclimatization of the wooden floor must take place for at least 48 hours before installation.
Note! When gluing engineered floor, mosaic parquet and basic parquet the substrate should have a surface tensile strength > 1.5 MPa, for solid and End grain wooden floors, the substrate should have a surface tensile strength > 2.0 MPa. Distance to wall or solid objects must be at least 5 mm depending on the type of wooden floor. No tongue and groove gluing. Always follow the wooden flooring manufacturer’s recommended installation instructions.
Working method:
- Apply adhesive with a notched trowel.
- Install the wooden floor in the working time for wet bonding within 30 minutes.
- Press the wood floor firmly to make full contact with the adhesive.
- Check to ensure full wetting of wooden floor back is achieved.
Installation of wooden floors must always be installed in wet adhesive.
Note! We recommend sanding and treatment with lacquer or oil no earlier than 24–48 hours after installation, depending on the prevailing working conditions. Always follow the wooden floor manufacturer’s recommended installation instructions.
CLEANING
Fresh stains can be removed with solvents adapted to the relevant surface treatment. Hardened glue can only be removed mechanically. Always follow the floor manufacturer's care instructions.
The working times specified in this product sheet are based on laboratory tests at a temperature of +18-20°C and humidity of 50% RH. Note that drying times are affected by temperature and humidity. Variations in local working conditions and practices affect the product’s performance and results. We guarantee that our products are of high quality in accordance with our quality management system. We take no responsibility for incorrect use of the product or prevailing working conditions that we have no control over. We cannot be held responsible for the final result. Correct use of the product assumes that the user has read and is aware of the contents of the work instructions, if any.
We recommend using suitable protective gloves and goggles. In case of contact with the product in the eyes, rinse immediately with water. Product that comes into contact with the skin should be washed with soap and water. See more information in the safety data sheet. More information on the disposal of the product and packaging can be found at www.kiilto.com.