Kiilto Nopea Slim Parkettiliima + hardener
Two-component, waterless, very fast curing polyurethane adhesive for the gluing of all parquet types (excluding engineered parquet). Suitable also for the repairing of top lamels of engineered parquet.
- for the gluing of all parquet types
- fast curing
- contains no water
Solvent-free, two-component, very fast curing polyurethane adhesive for parquet gluing. Ideal for repair works in small areas and repairing top lamels of engineered parquet. Suitable to be used with underfloor heating. ISO 17178 - hard.
|Package Size||EAN Code|
|1 kg + 0,17 kg||6411511464016|
Board subfloor: n. 0.75–2 m²/l (0.5–1.5 kg/m²)
Concrete subfloor: n. 1–1½ m²/l (1–1.5 kg/m²)
1 h (+20 °C)
Resin 1 kg / hardener 170 g
approx. 15 min (spread on the substrate)
1 kg (resin) + 170 g (hardener)
approx. 5–9 min (+20 °C, 50 % RH)
In unopened containers, above +1 °C, for 12 months.
Two-component, solvent-free polyurethane adhesive
Pot life of the adhesive mixture is approx. 5–9 minutes/+ 20 °C. Even a small temperature rise significantly shortens the pot life of the mixed adhesive and hardener.
Suitable substrates are steel-trowelled concrete, plywood, chipboard, cork board and wooden floor. Substrate must be dry, solid, smooth and free from dust and other materials that might impair adhesion. Remove the cement skin by sanding and vacuuming the dust prior to gluing. Concrete subfloor can be levelled with a Kiilto parquet subfloor levelling compound, if needed. (Levelling does not form a suitable subfloor for parquets over 22 x 70 x 500 mm.) Adhesive strength in tension of concrete and levelling compound must be 1.5 N/mm² at the minimum. If gluing on board, we recommend using min. 9 mm plywood board or similar. Follow also the parquet manufacturer's instructions and any applicable national regulations (in Finland SisäRYL 2013, the RYL Code of Building Practice). A hard adhesive reduces any dimensional variations caused by the moisture movement in wood, but at the same time it enables movement stress on the substrate.
Mix resin and hardener thoroughly just before use according to the given ratio. Spread the adhesive with a notched trowel on a surface of max. 1 m² and lay the parquet immediately onto the fresh adhesive surface. Check that a uniform adhesive layer is formed between the board and the substrate, but no adhesive bursts out from between the parquet boards. We recommend not sanding the parquet until 1 hour has passed of the gluing having been carried out. Fresh adhesive stains can be removed with acetone or xylene, dried adhesive only by mechanical means.
The information given in this product data sheet is based on our tests and our practical knowledge. The technical data is defined in standard conditions. Variations in local working conditions and methods will affect the product performance and result. Lopputulokseen vaikuttaa merkittävästi myös työn suoritustapa. We guarantee the high quality of our products according to our Quality Management System. No liability can be accepted from incorrect use of the product or prevailing conditions, over which we have no control. Thus, we cannot be held responsible for the final result. The correct use of the product presupposes that the user has made him/herself aware of the contents of the working instructions and procedure guide, if provided.
Avoid unnecessary skin contact and exposure with the fresh product, use safety gloves. Refer to material safety data sheet. For information on product and package disposal, visit www.kiilto.com.