Kestopur PL 110/8
1-component polyurethane adhesive

Kestopur PL 110/8 is a one-component polyurethane adhesive for the gluing of metal and insulation materials in sandwich panel constructions in the shipping industry.

Special features

  • Solvent-free
  • Suitable for automatic application




Kestopur PL 110/8 is a very fast, thin viscosity one-component moisture curing polyurethane adhesive. Strong foam building. Suitable for gluing for example wood, metal, insulation materials and glass fibre laminate. Preliminary adhesion tests must be carried out prior to full scale application. Due to low viscosity Kestopur PL 110/8 is ideal for automatic application. Note that a small amount of gas builds in the curing reaction, so ensure that one of the surfaces to be bonded is permeable. Does not contain solvents.

Package Size Product Code
Kestopur PL 110/8 220 kg/200 l T2423.200


Density/specific weight

approx. 1.4 kg/dm³




approx. 10 000 mPas (Brookfield RVT, 20°C)

Open time

max. 9 min (20°C, water spray)


150–300 g/m² depending on materials

Pressing time

ca. 4-5 min (65°C, waterspray)


Shelf-life if stored unopened at +20 °C is 6 months and at +30 °C max. 3 months.

Instructions for use

The surfaces to be bonded must be clean and dry. Remove oxides, grease etc. dirt with Kiilto Cleaner 303 or/and by sanding. Properly cleaned surface can be sanded to improve adhesion. Remove the sanding dust carefully prior to adhesive application. Apply the adhesive in an even layer on one of the surfaces. Water sprayed (5–10 g/m 2 ) on the adhesive layer shortens the pressing time. Remove fresh adhesive stains with a dry cloth and clean the surfaces with acetone or xylene. Hardened adhesive can be removed only mechanically. We recommend using adhesive at room temperature. However, the gluing can be carried out at lower temperatures (even at +5–10°C), but then the curing time will be much longer.

Additional information

The information given in this product data sheet is based on our tests and our practical knowledge. The technical data is defined in standard conditions. Variations in local working conditions and methods will affect the product performance and result. The result is also strongly affected by working methods. We guarantee the high quality of our products according to our Quality Management System. No liability can be accepted from incorrect use of the product or prevailing conditions, over which we have no control. Thus, we cannot be held responsible for the final result. The user of the product must test the product’s suitability for the intended application.

Environment and safety

Avoid unnecessary skin contact and exposure with the fresh product, use safety gloves. Refer to material safety data sheet. For information on product and package disposal, go to