Kestokol D 4800
EN 204/D4 adhesive

Kestokol D 4800 is EN 204 D4 classified PVAC-adhesive for face jointing of window and external door production wood blanks.

Special features

  • Short pressing time in high frequency press
  • 1-component
  • 12 months storage time




Kestokol D 4800 is a reactive PVAc-dispersion adhesive developed especially for high frequency applications. Due to its D4 water resistance durability class, Kestokol D 4800 can be used for exterior applications exposed to weather when covered with an adequate surface covering, or indoors for applications with frequent long-term exposure to running or condensation water.

Package Size Product Code
Kestokol D 4800 IBC cont T2297.994
Kestokol D 4800 kontti T2297.992



White, transparent after drying


2500 mPas (Brookfield, RVT +20 °C)

Open time

See instructions for use.


150 - 250 g/m²

Pressing time

20 min. (Pine, 12 % wood moisture, temperature 20 °C, 50 % RH)

Minimum film forming temperature


Wood moisture content

7 - 15 %


In unopened containers, above +1 °C, for 12 months. After long storing, stir before use.

Instructions for use

Check that the joints fit well. Apply adhesive evenly on one side. Assemble and press the parts together aiming at an even squeeze out for the whole length of the joint. Joints can be pressed in a cold, hot or high frequency press. The final strength and water resistance of the bond is reached within 7 days.

With some wood types the adhesive’s acidity may cause discolouration in the adhesive bond. If in contact with iron, some discolouration in the adhesive bond may also occur.

The consumption affects the open time of the adhesive as follows (pine 12 % wood moisture, 20 °C, 50 % RH):


  Consumption(g/m²) Open time (minutes)
 150 6
 180 9
 220 13
 250 17


Additional information

The information given in this product data sheet is based on our tests and our practical knowledge. The technical data is defined in standard conditions. Variations in local working conditions will affect the product performance and result. The result is also strongly affected by working methods. We guarantee the high quality of our products according to our Quality Management System. No liability can be accepted from incorrect use of the product or prevailing conditions, over which we have no control. Thus, we cannot be held responsible for the final result. The user of the product must test the product’s suitability for the intended application.

Environment and safety

Avoid unnecessary skin contact and exposure with the fresh product, use safety gloves. Refer to material safety data sheet. For information on product and package disposal, visit