Kestokol 98
2-component epi adhesive
Kestokol 98 is an EVA-based dispersion adhesive for the coating of wood boards.
Special features
- Fast
- Used in conjunction with Kovete D
Can be used also as a 1-component adhesive
Links
Materials
Kestokol 98 + Hardener D is a 2-component, isocyanate emulsion polymer adhesive with good water and heat resistance. Kestokol 98 can be used as an 1-component adhesive in less demanding applications.
Kestokol 98 + Hardener D can be used for the coating of wood boards with foil and is suitable for continuous coating pressing lines. Due to its speed, the product is suitable also for cold press lines.
| Package Size | Product Code |
|---|---|
| Kestokol 98 15 kg | T2428.015 |
| Kestokol 98 kontti | T2428.992 |
4,5
White, after drying transparent Glows under UV-light (100-390 nm).
100 : 2 - 5 % Hardener D
5000 mPas
5000–5500 mPas
White
The pot-life of the 2-component mixture is max. 120 min (+20 °C).
Short, less than 5 minutes.
The roller time of the mixture is 60–90 min.
60 - 150 g/m² depending on the application.
The pressing time in foil coating is short. When using a wood press, the pressing time is 1-10 minutes depending on the materials, the amount of adhesive and the temperature of the press.
0.1 - 0.5 N/mm² depending on application
+10 °C
5 - 10 %
In unopened containers, above +1 °C, for 12 months. After long storing, stir before use.
When used as a 2-component adhesive: Add 2–3 weight parts of Hardener D to 100 weight parts of Kestokol 98 by mixing carefully. If the pot-life is exceeded, the mixture starts to foam. New mixture can be added into an older mixture within the pot-life. When used as a 1-component adhesive, the adhesive is ready for use.
Apply adhesive in a uniform coat. Surfaces to be bonded must be free from dust, grease etc. The adhesive can be applied either on the foil or board. After the application of adhesive the foil should be immediately pressed. Use a roller or wood press for clamping the materials together. Since it is crucial that all air is pressed out of the bond we recommend using roller press. If using a level press, the surface must be rolled first to get the air out Extra heat, max. + 40 °C, may be used to shorten the curing time
The information given in this product data sheet is based on our tests and our practical knowledge. The technical data is defined in standard conditions. Variations in local working conditions and methods will affect the product performance and result. The result is strongly affected by working methods. We guarantee the high quality of our products according to our Quality Management System. No liability can be accepted from incorrect use of the product or prevailing conditions, over which we have no control. Thus, we cannot be held responsible for the final result. The user of the product must test the product’s suitability for the intended application.
Avoid unnecessary skin contact with and exposure to the uncured product: use safety gloves. Refer to the specific material safety data sheet. Go to www.kiilto.com for more information on product and package disposal.