Kiilto Pro 704 BSP
Curing and dust binding agent for floor-levelling compounds
A water-based curing and dust binding agent for levelling compound and concrete floors in areas that are exposed to light wear.
Special features
- Good water vapour permeability
- Good chemical resistance
- Very economical
Links
Materials
A water-based, diffusion-open surface treatment agent for floors levelled with a suitable levelling compound. The product protects the substrate from wear and tear, and makes it easier to clean. 704 BSP is suitable for the surface treatment of new floors, or maintenance treatment of previously untreated levelling compound or concrete floors. The product is also suitable for the treatment of cement-based levelling screeds if the levelled surface will remain uncoated for a long time.
Once the surface treatment agent has dried, the substrate can withstand direct, light mechanical stress, such as walking or light traffic with pneumatic tyres, but not studded tyres. The product has good chemical resistance, but is not intended for continuous exposure to water or chemical substances.
| Package Size | EAN Code |
|---|---|
| 5 l | 6411515511051 |
Recommendation: +10–20 °C (product, substrate and room).
max. 25 °C
M1
3 L (ready-made dilution) -> 20–30 m²
Coverage depends on substrate's porosity.
ca. 1
Freezes
1 part Kiilto Pro 704 BSP + 2 parts water
5 L
Can be stored unopened in a dry place for 1 year.
Sd < 0.2 m
The temperature of the agent, substrate and room should be +10...+20 °C when applying the product, but no more than +25 °C. 704 BSP can be applied on levelling compound no earlier than 24 hours after the compound’s application. Cement laitance must be removed from the concrete surface to ensure the absorption of the product. The dilution ratio of 704 BSP is 1:2 (1 part 704 BSP to + 2 parts clean water).
Apply the diluted product to the substrate with a brush. When applied with a sprayer, brush the product on the surface after spraying. Make sure that the levelled surface gets saturated with the product. Remove any excess product with a squeegee or other suitable tool.
Please note that certain types of rubber materials can cause surface discoloration. Test on a small area that the tool is suitable for the job. Drying should not be artificially accelerated by underfloor heating or a strong airflow.
The surface can be walked on about 30 minutes after the treatment. The final chemical and mechanical wear resistance will be achieved in about 3 days, depending on the surface temperature.
The information given in this product data sheet is based on our tests and our practical knowledge. The technical data is defined in standard conditions. Variations in local working conditions and methods will affect the product performance and result. We guarantee the high quality of our products according to our Quality Management System. No liability can be accepted from incorrect use of the product or prevailing conditions, over which we have no control. Thus, we cannot be held responsible for the final result. The correct use of the product presupposes that the user has made him/herself aware of the contents of the working instructions and procedure guide, if provided.
Avoid unnecessary skin contact and exposure with the fresh product, use safety gloves. Refer to material safety data sheet. For information on product and package disposal, go to www.kiilto.com.