Kiilto M1000 ECO
Floor and wall adhesive
A water-based, solvent-free dispersion adhesive for fixing PVC coverings, linoleum and textile carpets. Also suitable for attaching Kiilto KeraSafe+ waterproofing fabric, Kiilto dB Stop step sound insulation tiles and plastic wall coverings thicker than 0.6 mm. Also suitable for underfloor heating. IMO classified.
- easily spreadable floor and wall covering adhesive
- strong glue joint
- suitable for e.g. PVC coverings, linoleum and textile carpets
- also suitable for use in damp indoor areas
- coverage 4–6 m²/l
- does not contain APEO compounds, 2-ethyl hexanol, phthalates, plasticizers or solvents
Water-based, acryl-dispersion adhesive for installing vinyl floorings and tiles, linoleum, luxury vinyl tiles, rubber- and foam-backed textile flooring, and thick, over 0.6 mm, vinyl wall coverings on both porous and non-porous substrates in wet and dry areas. Suitable with underfloor heating and also for installing Kiilto KeraSafe+ Foil. Has M1 Emission Classification for Building Materials.
|Package Size||EAN Code|
1 l, 3 l, 10 l, 15 l
In unopened containers, above +1°C, for 18 months. After long storing, stir before use.
concrete: max. 85 % RH
wood: 8–12 %
wet bonding: 0–20 min.
late wet bonding: 20–60 min.
tacky gluing: 60–120 min.
(23 °C, 50 % RH)
Substrate must be dry, solid, smooth and free from dust and grease. We recommend smoothing the concrete substrate with a suitable Kiilto low-alkali levelling compound, which reduces the risk of damage in the covering or adhesive due to excess alkaline moisture. Joints in board floors must be smoothed. If installing the covering on building boards, follow the board manufacturer's instructions.
Stir the adhesive before use, if needed, and apply with a fine notched trowel or a roller. Use the wet-gluing method. Press the covering immediately to the substrate and rub it tightly on. If the covering is stiff or if it must be bended, let the adhesive permeate with air for 10–20 minutes before pressing the covering to the substrate. If installing an impermeable covering on a totally non-absorbent substrate, let the adhesive permeate with air for as long as 60 minutes before pressing the covering onto the surface. Alternatively, rub the length into fresh adhesive, lift up and let permeate with air for 20–30 minutes. After that, rub the length carefully onto the substrate. Remove fresh adhesive stains with water. Dried stains are removed with a strongly alkaline cleaner or xylene. Follow also the flooring manufacturer's installation instructions.
The information given in this product data sheet is based on our tests and our practical knowledge. The technical data is defined in standard conditions. Variations in local working conditions and methods will affect the product performance and result. The result is also strongly affected by working methods. We guarantee the high quality of our products according to our Quality Management System. No liability can be accepted from the incorrect use of the product or prevailing conditions, over which we have no control. Thus, we cannot be held responsible for the final result. The correct use of the product presupposes that the user has made him/herself aware of the contents of the working instructions and procedure guide, if provided.
Avoid unnecessary skin contact and exposure with the fresh product, use safety gloves. Refer to material safety data sheet. For information on product and package disposal, visit www.kiilto.com.