Kiilto Floor Plus
Floor and wall adhesive

Professional’s choice for gluing most floor covering materials. Suitable for quartz vinyl tiles and LVT floor coverings, i.e. vinyl planks and tiles. Also suitable for rubber floorings and floors with underfloor heating.

Special features

  • strong tack and high final strength
  • suitable for e.g. gluing of LVT-boards, quartz vinyl tiles and rubber coverings
  • easy to spread 
  • coverage 4-6 m²/l
  • does not contain plasticizers or 2-ethyl hexanol




A water-based floor and wall adhesive for vinyl floorings and -tiles, linoleum, rubber and textile floorings and thick, over 0.6 mm, vinyl wall coverings on both porous and non-porous substrates in wet and dry areas. Due to high final strength and strong bond, Kiilto Floor Plus is ideal for LVT tiles. Can be used with underfloor heating.

Notching of trowel
Notching of trowel
Package Size EAN Code
15 l 6411511012156
Application temperature

+18–25 °C


4–6 m²/l

Density/specific weight

1.1 kg/l

Frost resistance


Package sizes

15 l


In unopened containers, above +1°C, for 12 months. After long storing, stir before use.

Substrate humidity

concrete: max. 85 % RH
wood: 8–12 %


Acrylate copolymer

Working time

wet bonding: 0–20 min
late wet bonding: 20-60 min
tack gluing: 60-120 min (23 °C, 50 % RH)

Instructions for use

The substrate must be dry, solid, smooth and free from dust and grease. We recommend smoothing the concrete substrate with a suitable Kiilto low-alkali levelling compound, which reduces the risk of damage in the covering or adhesive due to excess alkaline moisture. Board joints must be smoothed as well. If installing covering on building boards, follow the board manufacturer's instructions.

Stir the adhesive before use, if needed, and apply with a fine notched trowel or a roller. On porous substrates, use the wet-gluing method: Press the covering immediately to the substrate and rub it onto the substrate firmly. If the covering is stiff or if it must be bended, let the adhesive permeate with air for 10–30 minutes before pressing the covering onto the substrate. If installing an impermeable covering on a totally non-absorbent substrate, let the adhesive permeate with air for more than 60 minutes before pressing the covering onto the surface. Or alternatively, rub the covering onto fresh adhesive, then lift up and let permeate with air for 20–30 minutes. After that rub the covering carefully onto the substrate. Remove fresh adhesive stains with water. Dried stains are removed with a strongly alkaline cleaner or xylene. Follow also the flooring manufacturer’s instructions on installation.

Additional information

The information given in this product data sheet is based on our tests and our practical knowledge. The technical data is defined in standard conditions. Variations in local working conditions and methods will affect the product performance and result. We guarantee the high quality of our products according to our Quality Management System. No liability can be accepted from incorrect use of the product or prevailing conditions, over which we have no control. Thus, we cannot be held responsible for the final result. The correct use of the product presupposes that the user has made him/herself aware of the contents of the working instructions and procedure guide, if provided.

Environment and safety

Avoid unnecessary skin contact and exposure with the fresh product, use safety gloves. Refer to material safety data sheet. For more information on product and package disposal, visit