Kiilto Pro Flexsilan
Parquet adhesive
One-component, water-free parquet adhesive designed especially for semi-elastic gluing of engineered wooden parquet, block and plank parquet. Suitable for gluing most types of parquets, and also for floors with underfloor heating.
Special features
- easy-spread parquet adhesive
- for gluing down engineered wooden parquet to the substrate
- coverage approx. 1.7 m²/l
- water-free, smp-adhesive
Links
Materials
One-component elastic, adhesive for gluing of parquet. Suitable for floors with underfloor heating. ISO 17178 - hard elastic. Has M1 Emission Classification for Building Materials.
| Package Size | EAN Code |
|---|---|
| 10 l / 16,5 kg | 6411513425107 |
+18–25 °C
paste spreads easily
approx. 1.7 m²/l, approx. 1.0 kg/m2
approx. 1.65 kg/l
freezing
approx. 30 min (+20 °C, 50 % RH)
10 l
In unopened containers, above +1 °C, for 9 months. After long storing, stir before use. An opened container must be used within 2–3 days.
concrete: max. 3,0 p-% or 80 % RH
wood: 8–12 %
Silyl-modified polymer (SMP)
Refer to both national and parquet manufacturer’s instructions on conditions during installation and use.
Suitable substrates are steel-trowelled concrete, board and wooden floor. Substrate must be dry, solid, smooth and free from dust and other materials that might impair adhesion. Remove the cement skin by sanding and vacuuming the dust prior to gluing. The concrete surface can be smoothed with a suitable Kiilto levelling compound, if needed. Adhesive strength in tension of concrete and levelling compound must be 1.5 N/mm² at the minimum. If gluing on board, we recommend using min. 9 mm plywood board or similar. Follow also the parquet manufacturer's instructions and any applicable national regulations (in Finland SisäRYL 2013). Elastic adhesive reduces stress on the substrate caused by moisture movement in wood, but it enables dimensional variation.
Carry out work at normal room temperature and humidity. Allow parquet boards and adhesive to acclimatise to the normal room temperature and humidity. Apply the adhesive evenly with a serrated trowel to an area that can be covered with parquet in approx. 30 minutes. Press the parquet firmly onto the substrate. Check that the back of the parquet is fully covered with adhesive. No tongue-and-groove gluing. Leave a clearance of 10–15 mm between solid structures, e.g., wall and parquet. Sanding and lacquering recommended not earlier than 24–48 hours after installing depending on prevailing conditions. Fresh adhesive stains can be removed with white spirit. Hardened adhesive can only be removed by mechanical means.
The information given in this product data sheet is based on our tests and our practical knowledge. The technical data is defined in standard conditions. Variations in local working conditions and methods will affect the product performance and result. We guarantee the high quality of our products according to our Quality Management System. No liability can be accepted from incorrect use of the product or prevailing conditions, over which we have no control. Thus, we cannot be held responsible for the final result. The correct use of the product presupposes that the user has made him/herself aware of the contents of the working instructions and procedure guide, if provided.
Avoid unnecessary skin contact and exposure with the fresh product, use safety gloves. Refer to material safety data sheet. For information on product and package disposal, visit www.kiilto.com.