Kestopur CS 10

Kestopur CS 10 is a two-component polyurethane adhesive for seaming artificial turf.

Special features

  • Good spreading properties
  • Good performance even in wet conditions
  • Mix ratio 10:1

Materials

Application

Polyurethane adhesive for gluing of seams of artificial grass filled with sand. For both manual and automatic application. Used in conjunction with Kestopur 200/S hardener. Easy spreading, good ridge forming. Work on the pitch can be continued soon after gluing. The adhesive has good bonding and gluing properties also in cold conditions. Can be used for gluing of reinforcing tapes also on flexible substrates. Preferred working conditions between +15–20 °C . Lowest working temperature +5 °C

Package Size Product Code
Kestopur CS 10 22 kg/20 l T3779.020
Type/binder

Polyurethane

Colors

green

Mixing ratio

10 weight part resin + 1 weight part hardener

Viscosity

100,000 mPas (Brookfield RVT 20 °C)

Pot life

Min. 1 h in the container

Open time

Applied on the substrate 0–30 min. Moisture in the surfaces to be bonded may shorten the open time.

Pressing time

Bonding time 12h /20 °C

Application temperature

Recommended working conditions at +15–20 °C (lowest temperature +5 °C)

Coverage

Building board 700–800 g/m², concrete 1–1.2 kg/m², seam joint 500 g/m²

Storage

Unopened at +10–25 °C for 12 months. After long storing, stir before use.

Instructions for use

The surfaces to be bonded must be clean. Depending on the case, remove grease and other impurities by solvent. First stir resin and then add the hardener and stir until the mixture is evenly colored. Apply the adhesive with e.g. notched trowel over the seam tape. When pressing the grass material and the joining tape together, ensure that the glue spreads evenly. With profiled coverings remember to use a trowel with a sufficiently deep trowel. The covering must be re-rolled within 1.5 hours from gluing. We recommend using a tile roller. If rolling is not possible, ensure during gluing with weights that the seams are fully and evenly covered with the adhesive. If gluing in damp conditions, protect open resin, hardener and resin-hardener containers from rain.

Additional information

The information given in this product data sheet is based on our tests and our practical knowledge. The technical data is defined in standard conditions. Variations in local working conditions and methods will affect the product performance and result. The result is strongly affected by working methods. We guarantee the high quality of our products according to our Quality Management System. No liability can be accepted from incorrect use of the product or prevailing conditions, over which we have no control. Thus, we cannot be held responsible for the final result. The user of the product must test the product’s suitability for the intended application.

Environment and safety

Avoid unnecessary skin contact with and exposure to the uncured adhesive: use safety gloves. Refer to material safety data sheet. For information on product and package disposal, visit www.kiilto.com.

Key Flag