Kestokol WR 05
2-component epi adhesive
Kestokol WR 05 is 2-component emulsion polymer isocyanate adhesive suitable for
glulam production according to JAS 111 norm (Norsk Träteknisk Institutt (NTI), 2011) conditions class C.
Special features
- Unprotected outside use
- Excellent weather resistance
Links
Materials
Kestokol WR 05 + Hardener WR is an emulsion polymer isocyanate adhesive that has excellent resistance against climatic stress. It fulfils the boiling water resistance requirements according to JIS K 6806-1985 (1995) and EN 204/D4 durability class. It is also approved to be used in glulam production according to the JAS 111 norm (Norsk Träteknisk Institutt (NTI), 2011).
Kestokol WR 05 + Hardener WR can be used in objects exposed to constantly changing weather conditions such as garden furniture, boat gluing’s (not for parts below the water level!) and specific glulam applications.
| Package Size | Product Code |
|---|---|
| Kestokol WR 05 8 kg | T3675.010 |
| Kestokol WR 05 IBC cont | T3675.994 |
1,15 kg/dm
6.5 - 8.0
100 : 15
9000 mPas (Brookfield RVT +20 °C)
13500 mPas (Brookfield RVT +20 °C) immediately after addition of hardener
light beige
The pot-life of the mixture is at most 20 min (+20 °C).
5 - 12 min (consumption 150 - 220 g/m²)
140 - 240 g/m²
minimum 20 min
+5 °C
6 - 15 %
EN 14257 (Watt 91): 12,5 N/mm
In unopened containers, above +1 °C, for 6 months. After long storing, stir before use.
Add 15 weight parts of Hardener WR into 100 weight parts of Kestokol WR 05 adhesive and mix well. If the pot-life of the mixture is exceeded, the mixture starts to foam. New mixture can be added into an older mixture within the pot-life.
Check that the joints fit well. Apply adhesive evenly on one side. Assemble and press the parts together aiming at an even squeeze out for the whole length of the joint. Joints can be pressed in a cold, hot or high frequency press. In order to determine the necessary pressing time and ensure the adhesive joint strength, adequate tests are to be carried out before use in full-scale production.
Parts may need to be stored for a while before further machining to reach the necessary bond strength. The final strength and water resistance of the bond is reached within 7 days.
Technical data for general and specific glulam applications:
| General use | Specific glulam applications | |
| Consumption | 140 - 160 g/m² | 200 - 240 g/m² |
| Open time | 5 - 7 min | 7 - 12 min |
| Pressing time (minimum) | 20 min | 30 min |
The information given in this product data sheet is based on our tests and our practical knowledge. The technical data is defined in standard conditions. Variations in local working conditions will affect the product performance and result. The result is also strongly affected by working methods. We guarantee the high quality of our products according to our Quality Management System. No liability can be accepted from incorrect use of the product or prevailing conditions, over which we have no control. Thus, we cannot be held responsible for the final result. The user of the product must test the product’s suitability for the intended application.
Avoid unnecessary skin contact and exposure with the fresh product, use safety gloves. Refer to material safety data sheet. For information on product and package disposal, visit www.kiilto.com.