Kestokol D 300 HV
EN 204/D3 adhesive
Kestokol D 300 HV is an EN 204 D3 -classified PVAC-adhesive for wood.
- Storage life 12 months
- Suits well for foil coating of wooden boards
Kestokol D 300 HV is a reactive PVAc-dispersion adhesive with a bit higher viscosity. It is well suited for gluing of solid wood, parquet, bathroom fixtures, laminate and particularly for foil coating of wood-based boards. Due to its D3 durability class, Kestokol D 300 HV -adhesive can be used for interior applications that have frequent exposure to high humidity, or running or condensation water, or for exterior applications which are not exposed to weather.
|Package Size||Product Code|
|Kestokol D 300 HV 15 kg||T2542.015|
|Kestokol D 300 HV IBC cont||T2542.994|
|Kestokol D 300 HV Schütz cont||T2542.996|
White, transparent after drying
Strength 24 h +45 °C / 90 % relative humidity after climate stress cycle > 5 N/mm
9500 mPas (Brookfield RVT +20 °C)
See instructions for use.
120 - 150 g/m² (solid wood)
60 - 100 g/m² (foil coating)
20 min. (Pine, moisture content of wood 12 %, temperature 20 °C, 65 % RH)
6 - 15 %
Unopened, above +1°C, for 12 months. After long storing, stir before use.
Check that the joints fit well. Apply adhesive evenly on one side. Assemble and press the parts together aiming at an even squeeze out for the whole length of the joint. Joints can be pressed in a cold, hot or high frequency press. The final strength and water resistance of the bond is reached within 7 days.
With some wood types the adhesive’s acidity may cause discolouration in the adhesive bond. If in contact with iron, some discolouration in the adhesive bond may also occur.
The consumption affects the open time of the adhesive as follows (pine 12 % wood moisture, 23 °C, 50 % RH):
|Consumption (g/m²)||Open time (minutes)|
The information given in this product data sheet is based on our tests and our practical knowledge. The technical data is defined in standard conditions. Variations in local working conditions will affect the product performance and result. The result is also strongly affected by working methods. We guarantee the high quality of our products according to our Quality Management System. No liability can be accepted from incorrect use of the product or prevailing conditions, over which we have no control. Thus, we cannot be held responsible for the final result. The user of the product must test the product’s suitability for the intended application.
Avoid unnecessary skin contact and exposure with the fresh product, use safety gloves. Refer to material safety data sheet. For information on product and package disposal, visit www.kiilto.com.