Kestofol P/H is a fast bonding dispersion adhesive for gluing melamine PVC foils to wood-based boards. Gives a high-quality, smooth surface.

Package Size Product Code
Kestofol P/H 15 kg T1482.015





18,000 mPas (Brookfield 6/20, +20 °C)

Open time

approx. 4 min


80–120 g/m²

Compression pressure

0.1–0.15 N/mm²

Application temperature


Air humidity

50–60 %


In unopened containers at +20 °C for 12 months. After long storing, stir before use.

Instructions for use

Adhesive’s properties depend highly on prevailing conditions, such as moisture of wood and ambient air, temperature, absorbency and amount of adhesive applied, so the given values can be regarded only as guidance. In order to determine the necessary pressing time and ensure the adhesive joint strength, adequate tests are to be carried out before use in full-scale production. A higher temperature shortens the required pressing time. See the instructions given by the foil manufacturer.

The surfaces to be bonded must be free from dust, grease etc. Temperature of the adhesive and the material should be above +15°C. However, the bond strength will be achieved also at lower temperatures (above +3°C), but the drying time will be longer. If using a small amount of adhesive, adequate tests are to be carried out to ensure required strength.

The adhesive can be applied on either the foil or the board. Once applied, press the foil onto the sheet immediately. Use a roller or level press to clamp the pieces together. Since it is crucial that all air is pressed out of the bond, we recommend using a roller press. If using a level press, the surface must be rolled first to get all air out. Coated boards should then be placed in a pile. Allow the boards to set for at least two hours before further treatment.

Additional information

The information given in this product data sheet is based on our tests and our practical knowledge. The technical data is defined in standard conditions. Variations in local working conditions and methods will affect the product performance and result. The result is strongly affected by working methods. We guarantee the high quality of our products according to our Quality Management System. No liability can be accepted from incorrect use of the product or prevailing conditions, over which we have no control. Thus, we cannot be held responsible for the final result. The user of the product must test product’s suitability to the intended application.

Environment and safety

Avoid unnecessary skin contact with and exposure to the fresh product: use safety gloves. Refer to material safety data sheet. For information on product and package disposal, visit

Key Flag