Kiilto CR DF Pikamärkätilatasoite 0-5 (10) mm

A very fast drying finishing plaster for wet areas. Can also be used in dry areas and for over levelling air leakage repair materials on walls before the final finish.

Special features

  • extra fast drying
  • dust reduced
  • overall plastering 0–5 mm, partial plastering 0–10 mm




Links

Materials

Application

Kiilto CR DF Pikamärkätilatasoite is suitable for plastering interior walls and ceilings. Not suitable for areas that are permanently under water (for example, swimming pools). When plastering a waterproofed surface we recommend using Kiilto Rappausverkko reinforcing mesh with the plaster. The plastered surface can be waterproofed with Kiilto waterproofing membranes, tiled or painted.

Package Size EAN Code
12,5 kg 6411512279107
Application temperature

recommendation +18–20 °C, lowest operating temperature +5 °C

Bond strength

> 0.5 MPa (EN 998-1)

Coatable

overall plastering approx. 1 h, partial plastering 24 h

Colors

grey

Compression strength

class CSIV (EN 998-1)

Coverage

1 mm layer/m² solid matter weights approx. 1.4 kg

Layer thickness

overall plastering 0–5 mm, partial plastering 0–10 mm

Mixing ratio

3.0–3.4 l water / 12.5 kg bag

Package sizes

12.5 kg bag

Storage

In an unopened package 6 months in dry conditions

Substrate humidity

concrete < 90 % RH

Type/binder

Polymer-cement-sand -based powder

Working time

20–30 minutes (+18 °C)

Instructions for use

The surfaces to be plastered must be solid, clean and free from dust. Weak and loose particles must be removed carefully. Dry surfaces must be lightly moistened prior to plastering.

Strew CR DF powder slowly in cool (+18–20 °C), clean water constantly stirring until a smooth, even mass is formed. Let the mix mature for approx. 2-3 min and then remix once again. The plaster is applied by hand with a steel trowel. When using Kiilto Rappausverkko -reinforcing mesh embed it into fresh plaster. Smooth the surface with a steel trowel to leave the mesh in the middle of the plaster layer.

Carry out plaster application work at the usually prevailing room temperature. Prevailing conditions, such as temperature of the room, plaster and water, substrate quality and humidity and relative humidity affect significantly the setting and drying time. Our recommendations can therefore be used as a guideline only.

Additional information

The information given in this product data sheet is based on our tests and our practical knowledge. The technical data is defined in standard conditions. Variations in local working conditions and methods will affect the product performance and result. The result is also strongly affected by working methods. We guarantee the high quality of our products according to our Quality Management System. No liability can be accepted from incorrect use of the product or prevailing conditions, over which we have no control. Thus, we cannot be held responsible for the final result. The correct use of the product presupposes that the user has made him/herself aware of the contents of the working instructions and procedure guide, if provided.

Environment and safety

Avoid unnecessary skin contact and exposure with the fresh product, use safety gloves. Refer to the material safety data sheet. For information on product and package disposal, visit www.kiilto.com.

M1 emission classification for building material
CE marking
LEED
Key Flag