Akvapur SM 5070
Akvapur SM 5070 is an adhesive for foil coating in interior door manufacture
Special features
- 1-component
- Good surface quality
Links
Materials
Akvapur SM 5070 is used for the PVC foil coatings of MDF or other wood based board blanks milled with cutter when using membrane or deep drawing techniques. Suitable also in manufacture of upholstered furniture and office chairs.
Package Size | Product Code |
---|---|
Akvapur SM 5070 15 kg | T3860.015 |
PUD
6
3000 mPas (Brookfield, RVT +20°C)
To activate the adhesive film the temperature of at least +55-60°C is needed. The adhesive must be activated within 20 hours after the adhesive application.
+70°C
Stir Akvapur SM 5070 carefully. The surfaces to be glued should be clean from dust, grease etc. Apply an even uniform coat of the adhesive onto the board blanks with an air assisted airless spray gun (Air mix) or a high pressure spray gun. Let the adhesive dry until transparent. After the drying time the coating foil is preheated and drawn and/or pressed onto the board blank using a deep drawing or membrane press. See the instructions given by the foil and machine manufacturer.
The information given in this product data sheet is based on our tests and our practical knowledge. The technical data is defined in standard conditions. Variations in local working conditions and methods will affect the product performance and result. The result is strongly affected by working methods. We guarantee the high quality of our products according to our Quality Management System. No liability can be accepted from incorrect use of the product or prevailing conditions, over which we have no control. Thus, we cannot be held responsible for the final result. The user of the product must test the product’s suitability for the intended application.
Avoid unnecessary skin contact with and exposure to the uncured product: use safety gloves. Refer to the specific material safety data sheet. Go to www.kiilto.com for more information on product and package disposal.