Akvapur SM 2000

Akvapur SM 2000 is a foil coating adhesive for furniture doors.

Special features

  • 2-component
  • Very good and even surface quality
  • Low activation temperature
  • High after heat resistance

Materials

Product Information
Application

Akvapur SM 2000 is used for the PVC foil coatings of MDF or other wood-based board blanks milled with cutter when using membrane or deep drawing techniques.

Package Size Product Code
Akvapur SM 2000 15 kg T2251.015
Technical Information
Type/binder

PUD

pH

8.5

Mixing ratio

Akvapur SM 2000: 100 weight parts
Hardener C: 3-6 weight parts

Viscosity

2000 mPas (Brookfield, RVT +20°C)

Working time

The working time of the adhesive/hardener-mixture is 6-8 hours.

Application temperature

To activate the adhesive film, a minimum temperature of 55-60°C is required. The adhesive must be activated within 20 hours following the application of the adhesive.

Temperature resistance when dry

After heat resistance 90-100°C

Coatable

In room temperature 30-60min

Storage

In unopened containers at +20 °C for 12 months.

Instructions and Safety
Instructions for use

Thoroughly mix Akvapur SM 2000 with Hardener C. The surfaces to be glued should be free from dust, grease etc. Apply an even uniform coat of the adhesive onto the board blanks with an air assisted airless spray gun (Airmix®) or a high pressure spray gun. Let the adhesive dry until transparent. After the drying time, the coating foil is preheated and drawn and/or pressed onto the board blank using a deep drawing or membrane press. When the thermal activation is sufficient enough, the after-heat resistance of the adhesive joint (PVC/MDF) will be high, ca. 90-100°C. See the instructions provided by the foil and machine manufacturer.

Additional information

The information given in this product data sheet is based on our tests and our practical knowledge. The technical data is defined in standard conditions. Variations in local working conditions and methods will affect the product performance and result The result is strongly affected by working methods. We guarantee the high quality of our products according to our Quality Management System. No liability can be accepted from incorrect use of the product or prevailing conditions, over which we have no control. Thus, we cannot be held responsible for the final result. The user of the product must test product’s suitability to the intended application.

Environment and safety

Avoid unnecessary skin contact with and exposure to the fresh product: use safety gloves. Refer to material safety data sheet. For information on product and package disposal, visit www.kiilto.com.

Certificates
Key Flag