Checklist

  • You can add products to your checklist.

By emailing the checklist to yourself, you will receive the Product Brochure and Safety Data Sheet to your inbox in PDF format.

SubmitPrint

Kiilto SK Märkätilatasoite 1–3 (10) mm

Wall plaster for levelling walls and ceilings in wet areas. Particularly for straightening concrete and blocks walls prior to waterproofing and tiling. Partial levelling 1-10 mm, over plastering 1-3 mm. Also for exterior applications. Cementitious.

Special features

  • cementitious wall plaster
  • dry and wet areas
  • when coated suitable also for exterior use
  • drying time over plastering 1 vrk, partial levelling 1–3 d
  • over plastering 1–3 mm, partial levelling 1–10 mm
  • coverage 1,3 kg/m²/mm

Application

Kiilto SK is a wall plaster for interior walls and ceilings. Suitable for plastering various rock material surfaces and gypsum boards. The finished surface can be tiled or waterproofed with Kiilto waterproofing membrane. It can also be over plastered with other Kiilto wall plasters depending on the application. In outdoor use the finished surface must be coated.

Coverage

1 mm layer/m² solid matter weights approx. 1.3 kg

Package Size

EAN Code

20 kg 6411512154206
Package Size 20 kg
EAN Code 6411512154206
 

Type/binder

Polymer-cement-limestone -based powder

Colors

Grey

Compression strength

CSIV (EN 998-1)

Mixing ratio

5.0-5.5 l water / 20 kg bag

Curing rate

approx. 1 d (+18 °C) (depending on layer thickness and prevailing conditions)

Working time

3–4 hours (+18 °C)

Working conditions

recommendation: +18–20 °C, lowest operating temperature +5 °C

Package sizes

20 kg bag

Substrate humidity

concrete < 90 % RH

Coverage

1 mm layer/m² solid matter weights approx. 1.3 kg

Layer thickness

partial levelling 1-10 mm, over plastering 1-3 mm.

Max. grain size

0.5 mm

Storage

In an unopened package max. 1 year in dry conditions.

Instructions for use

The surfaces to be plastered must be solid, clean and free from dust. Dry surfaces are moistened prior to plastering (not board surfaces). A new coat should not be applied until the previous one is dry. If needed, the surface should be carefully sanded and cleaned before applying a new plaster coat.



Strew Kiilto SK powder slowly in cool (+18–20 °C), clean water constantly stirring until a smooth, even mass is formed.

Let the mix mature for approx. 10-15 min and then remix once again. Apply the plaster by hand with a steel trowel or spray with a spraying gun for plasters. Also, the sprayed coat should be levelled by hand with a steel trowel.

Environment and safety

Avoid unnecessary skin contact and exposure with the fresh product, use safety gloves. Refer to material safety data sheet. For information on product and package disposal, visit www.kiilto.com.

M1CELEEDNordic EcolabelMade in Finland, Key flag