Checklist

  • You can add products to your checklist.

By emailing the checklist to yourself, you will receive the Product Brochure and Safety Data Sheet to your inbox in PDF format.

SubmitPrint

Kiilto GP Nauhoitustasoite 1–3 mm

Special joint plaster for fixing of reinforcing tapes and smoothing the joints of gypsum board plates. Suitable for dry interior walls and ceilings. Max. layer thickness 3 mm. Adhesive based.

Special features

  • cementitious binder, for fixing reinforcing tapes to gypsum boards
  • dry areas
  • drying time 1 d
  • over plastering max 3 mm
  • coverage 1,2 kg/m²/mm

Application

Kiilto GP is a polymer based joint plaster for interior walls and ceilings. Especially suitable for fixing of reinforcing tapes and smoothing the joints of gypsum board plates. Can be used for over plastering walls for later painting and wallpapering. Not suitable under tiling or wall vinyl.

Coverage

1 mm layer/m² solid matter weights approx. 1.2 kg

Package Size

EAN Code

20 kg 6411512004204
Package Size 20 kg
EAN Code 6411512004204
 

Type/binder

Polymer-limestone -based powder

Colors

Light

Bond strength

> 0,3 MPa (EN 15824)

Flexural strength

> 320 N (EN 13963)

Mixing ratio

7,0–7,5 l water / 20 kg plaster powder, 1 part by volume water / 2,5 parts by volume plaster powder

Curing rate

approx. 1 d (+18 °C) (depending on prevailing conditions)

Classifications and certificates

stress grading RL01...RL04 of paintable surfaces (The RYL Code of building practice 2012)

Working time

approx. 24 hours (+18 °C)

Working conditions

recommendation +18–20 °C, lowest operating temperature +10 °C

Package sizes

20 kg bag

Substrate humidity

concrete < 90 % RH

Coverage

1 mm layer/m² solid matter weights approx. 1.2 kg

Layer thickness

1-3 mm

Max. grain size

0.2 mm

Storage

In unopened containers, above +1 °C, for 1 year.

Instructions for use

The surfaces to be plastered must be clean, dry and free from dust. Let the layer dry completely before applying a new one. If needed, the surface should be carefully sanded and cleaned before applying a new plaster coat.



Strew the plaster slowly in cool (+18 °C), clean water constantly stirring until a smooth, even mass is formed. Let the mix mature for approx. 15 min and then remix once again. If left over plaster is saved for the next day, the container should be covered carefully to avoid drying.



Fixing of reinforcing tapes: Apply the plaster in joint and press the tape firm in plaster with a narrow steel trowel. After that smooth the joint by applying plaster over the reinforcing tape using a broad steel trowel. After drying the surface can be sanded, if necessary.

Environment and safety

Avoid unnecessary skin contact and exposure with the fresh product, use safety gloves. Refer to material safety data sheet. For information on product and package disposal, visit www.kiilto.com.

M1CELEEDMade in Finland, Key flag