You can add products to your checklist.
Akvapur SM 1400 is a foil coating adhesive for furniture doors.
Akvapur SM 1400 is used for the PVC foil coatings of MDF or other wood-based board blanks milled with cutter when using membrane or deep drawing techniques.
|Akvapur SM 1400 15 kg||T2909.015|
|Package Size||Akvapur SM 1400 15 kg|
4000 mPas (Brookfield, RVT +20°C)
To activate the adhesive film, a minimum temperature of 70°C is required. The adhesive joint must be activated within 72 hours following the application of the adhesive
After heat resistance 80-90°C
In room temperature 30-60min
In unopened containers at +20 °C for 6 months.
Stir properly before use. The surfaces to be glued should be free from dust, grease etc. Apply an even uniform coat of the adhesive onto the board blanks with an air assisted airless spray gun (Airmix®) or a high pressure spray gun. Let the adhesive dry until transparent. After the drying time, the coating foil is preheated and drawn and/or pressed onto the board blank using a deep drawing or membrane press. When the thermal activation is sufficient enough, the after-heat resistance of the adhesive joint (PVC/MDF) will be high, ca. 80-90°C. When gluing, follow the instructions provided by the foil and machinery manufacturers.
Avoid unnecessary skin contact with and exposure to the fresh product: use safety gloves. Refer to material safety data sheet. For information on product and package disposal, visit www.kiilto.com.